[PATCH 2/2] pci: new layout: move footnote

Legacy footnotes belong directly within text.

Signed-off-by: Michael S. Tsirkin <>
---
 virtio-v1.0-wd01-part1-specification.txt | 14 +++++++-------
 1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/virtio-v1.0-wd01-part1-specification.txt b/virtio-v1.0-wd01-part1-specification.txt
index 71ddcc5..6471ccc 100644
--- a/virtio-v1.0-wd01-part1-specification.txt
+++ b/virtio-v1.0-wd01-part1-specification.txt
@@ -849,7 +849,7 @@ When used through the legacy interface, the virtio header looks as follows:
 
 
 If MSI-X is enabled for the device, two additional fields
-immediately follow this header:[5]
+immediately follow this header:
 
 
 +------------++----------------+--------+
@@ -862,6 +862,12 @@ immediately follow this header:[5]
 | (MSI-X)    || Vector         | Vector |
 +------------++----------------+--------+
 
+Note: When MSI-X capability is enabled, device specific configuration starts at
+byte offset 24 in virtio header structure. When MSI-X capability is not
+enabled, device specific configuration starts at byte offset 20 in virtio
+header.  ie. once you enable MSI-X on the device, the other fields move.
+If you turn it off again, they move back!
+
 Immediately following these general headers, there may be
 device-specific headers:
 
@@ -3150,12 +3156,6 @@ the non-PCI implementations (currently lguest and S/390).
 This is only allowed if the driver does not use any features
 which would alter this early use of the device.
 
-[5] When MSI-X capability is enabled, device specific configuration starts at
-byte offset 24 in virtio header structure. When MSI-X capability is not
-enabled, device specific configuration starts at byte offset 20 in virtio
-header.  ie. once you enable MSI-X on the device, the other fields move.
-If you turn it off again, they move back!
-
 [6] The 4096 is based on the x86 page size, but it's also large
 enough to ensure that the separate parts of the virtqueue are on
 separate cache lines.
-- 
MST