[PATCH 06/14] legacy pci layout: confirmance statements

---
 content.tex | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/content.tex b/content.tex
index 2f467d5..cbbad09 100644
--- a/content.tex
+++ b/content.tex
@@ -1227,13 +1227,16 @@ at BAR selected by \field{cap.bar} and store the first \field{cap.length} bytes
 
 \subsubsection{Legacy Interfaces: A Note on PCI Device Layout}\label{sec:Virtio Transport Options / Virtio Over PCI Bus / PCI Device Layout / Legacy Interfaces: A Note on PCI Device Layout}
 
-Transitional devices should present part of configuration
+Transitional devices MUST present part of configuration
 registers in a legacy configuration structure in BAR0 in the first I/O
 region of the PCI device, as documented below.
+When using the legacy interface, transitional drivers
+MUST use the legacy configuration structure in BAR0 in the first
+I/O region of the PCI device, as documented below.
 
-When accessed through the legacy interface the driver MAY access
+When using the legacy interface the driver MAY access
 the device-specific region using any width accesses, and
-a transitional device MUST present it with the same results as
+a transitional device MUST present driver with the same results as
 when accessed using the “natural” access method (i.e.
 32-bit accesses for 32-bit fields, etc).
 
@@ -1290,7 +1293,7 @@ Purpose & Device Specific & \\
 
 Note that only Feature Bits 0 to 31 are accessible through the
 Legacy Interface. When used through the Legacy Interface,
-Transitional Devices must assume that Feature Bits 32 to 63
+Transitional Devices MUST assume that Feature Bits 32 to 63
 are not acknowledged by Driver.
 
 As legacy devices had no \field{config_generation} field,
-- 
MST