[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [List Home]
Subject: Re: [PATCH] iommu: offered -> negotiated
On Tue, Apr 12 2022, Cornelia Huck <cohuck@redhat.com> wrote:
Hmm... it seems the original proposal had been too buried (or I actually
fat-fingered things in my patch).
What do we do now? Revert, and re-apply a new patch after perhaps some
further discussion? (Would likely be for 1.3, though. Maybe also vote,
as this does not seem to be as straightforward as I thought.)
> All those clauses actually apply whenever the feature is negotiated,
> not merely offered. Rename to clarify things.
>
> Signed-off-by: Cornelia Huck <cohuck@redhat.com>
> ---
> virtio-iommu.tex | 10 +++++-----
> 1 file changed, 5 insertions(+), 5 deletions(-)
>
> diff --git a/virtio-iommu.tex b/virtio-iommu.tex
> index f8cbe8895f0d..efe1000ac2d2 100644
> --- a/virtio-iommu.tex
> +++ b/virtio-iommu.tex
> @@ -232,22 +232,22 @@ \subsection{Device operations}\label{sec:Device Types / IOMMU Device / Device op
> Creating mappings aligned on large page sizes can improve performance
> since they require fewer page table and TLB entries.
>
> -\item If the VIRTIO_IOMMU_F_DOMAIN_RANGE feature is offered,
> +\item If the VIRTIO_IOMMU_F_DOMAIN_RANGE feature is negotiated,
> \field{domain_range} describes the values supported in a \field{domain}
> - field. If the feature is not offered, any \field{domain} value is valid.
> + field. If the feature is not negotiated, any \field{domain} value is valid.
>
> -\item If the VIRTIO_IOMMU_F_INPUT_RANGE feature is offered,
> +\item If the VIRTIO_IOMMU_F_INPUT_RANGE feature is negotiated,
> \field{input_range} contains the virtual address range that the IOMMU is
> able to translate. Any mapping request to virtual addresses outside of
> this range fails.
>
> - If the feature is not offered, virtual mappings span over the whole
> + If the feature is not negotiated, virtual mappings span over the whole
> 64-bit address space (\texttt{start = 0, end = 0xffffffff ffffffff})
> \end{itemize}
>
> An endpoint is in bypass mode if:
> \begin{itemize}
> - \item the VIRTIO_IOMMU_F_BYPASS_CONFIG feature is offered and:
> + \item the VIRTIO_IOMMU_F_BYPASS_CONFIG feature is negotiated and:
> \begin{itemize}
> \item config field \field{bypass} is 1 and the endpoint is
> not attached to a domain. This applies even if the driver
> --
> 2.34.1
[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [List Home]